Programming and Relearning
Inspection after InstallationSETTING OF LIMIT SWITCH
Setting of Limit Switch
Set the limit switch if any of the following work has been done (integrated in the motor).
- Removal and installation of the motor from the regulator.
- Operation of the regulators as a unit.
- Installation of the new glass.
- Installation of the new glass run.
Resetting
After installing each component to the vehicle, follow the steps below.
1. Raise the glass to the top position.
2. While pressing and holding the reset switch, lower the glass to the lower position.
3. Release the reset switch, and check the reset switch returns to the original position, and then raise the glass to the top position.
CAUTION: Do not operate the glass automatically to raise the glass to the top position.