Crash Zone Sensor

CRASH ZONE SENSOR

Removal and Installation

REMOVAL

CAUTION:
- Before servicing the SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
- Replace crash zone sensor if it has been dropped or sustained an impact.
- Do not disassemble crash zone sensor.

1. Disconnect the negative and positive battery cables, then wait at least 3 minutes.
2. Remove front grille.




3. Disconnect the crash zone sensor harness connector.
4. Remove crash zone sensor nuts.

INSTALLATION
Installation is in the reverse order of removal.
- After the work is complete, perform self-diagnosis to check that no malfunction is detected. Refer to SRC-13, "SRS Operation Check". Diagnostic Procedure 1