Rear Suspension

Removal and Installation

REMOVAL





1. Disconnect the stabilizer bar ends from the connecting rods using power tool.





2. Remove the stabilizer bar clamps using power tool, and remove the stabilizer bar bushings.
3. Remove the stabilizer bar.

INSPECTION AFTER REMOVAL
^ Check the stabilizer bar for any deformation, cracks, or damage and replace if necessary.
^ Check the rubber bushings for deterioration, or cracks and replace if necessary.

INSTALLATION
Installation is in the reverse order of removal.
^ Tighten the nuts and bolts to specification. Refer to RSU-8, "Component". Rear Suspension





^ Install the stabilizer bar with the ball joint sockets properly aligned.
^ Install the stabilizer bar bushing and clamp so they are positioned inside of the sideslip prevention clamp on the stabilizer bar.