Removal and Installation

FILLET MOLDING


Removal and Installation


REMOVAL

FRONT FILLET MOLDING
1. Remove front fillet molding fixing screws.





2. Disengage the pawls from the front fillet molding (1) frontal part.





3. Using a remover tool (A), disengage the clips from the front fillet molding (1) by starting from the front.

CAUTION:
- Apply a protective tape (B) on the body to protect the painted surface from damage.
- Disengage the clips slowly and carefully.
- Never pull the front fillet molding (1) strongly.

REAR FILLET MOLDING
1. Remove rear mud guard fixing screws, and then remove rear mud guard.
2. Remove rear fillet molding fixing screws.





3. Disengage the pawls from the rear fillet molding (1) rear side.





4. Using a remover tool (A), disengage the clips from the rear fillet molding (1) by starting from the rear.

CAUTION:
- Apply a protective tape (B) on the body to protect the painted surface from damage.
- Disengage the clips slowly and carefully.
- Never pull the rear fillet molding (1) strongly.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- When installing, check visually the fillet molding and the clips, then replace them with new parts if they have been damaged.
- When installing fillet molding, check that blind clips are securely fitted in panel holes on body, and then press them in.