Removal and Installation

WATER OUTLET AND WATER PIPING


Removal and Installation


REMOVAL
1. Remove engine undercover with power tool.
2. Drain engine coolant. Refer to Draining.

CAUTION:
- Perform this step when the engine is cold.
- Never spill engine coolant on drive belt.
3. Remove engine cover. Refer to Exploded View.
4. Remove air duct and air cleaner case assembly (RH and LH). Refer to Exploded View.
5. Remove intake manifold collector. Refer to Exploded View.
6. Remove intake manifold. Refer to Exploded View.
7. Remove reservoir tank. Refer to Exploded View.
8. Remove oil level gauge and guide. Refer to Exploded View or Exploded View.
9. Remove radiator hose (upper) and heater hose.
10. Remove water outlet (front) and water outlet pipe.
11. Separate engine harness removing their bracket from water outlet (rear).
12. Remove engine coolant temperature sensor if necessary.

CAUTION:
Be careful not to damage engine coolant temperature sensor.
13. Remove heater pipe, water bypass pipe, and water outlet (rear).

INSTALLATION
Note the following, and install in the reverse order of removal.
- Securely insert each hose, and install clamp at a position where it does not interfere with the pipe bulge.
- When inserting water outlet pipe and water bypass pipe into water outlet, apply neutral detergent to O-ring.

CAUTION:
Never allow water outlet (rear) to nip O-rings when installing water outlet pipe and water bypass pipe.