Removal and Installation

A/T FLUID TEMPERATURE SENSOR 2


Removal and Installation


REMOVAL
1. Disconnect the battery cable from the negative terminal.
2. Drain ATF through drain plug.
3. Remove exhaust mounting bracket. Refer to Exploded View.





4. Disconnect heated oxygen sensor 2 connectors (A).
5. Remove heated oxygen sensor 2 harness (B) from clips (1).
6. Remove bracket (2) from transmission assembly.





7. Remove clips (1).
8. Remove oil pan (2) and oil pan gasket.





9. Remove magnets (1) from oil pan.
10. Disconnect A/T fluid temperature sensor 2 connector (A).






CAUTION:
Be careful not to damage connector.
11. Disengage terminal clip ( ).





12. Remove A/T fluid temperature sensor 2 (1) with bracket (2) from control valve with TCM.





13. Remove bracket (1) from A/T fluid temperature sensor 2 (2).

INSTALLATION
Note the following, and install in the reverse order of removal.

CAUTION:
- Be careful not to damage connector.
- Never reuse drain plug and drain plug gasket.
- Adjust bolt hole of bracket to bolt hole of control valve with TCM when installing A/T fluid temperature sensor 2 (with bracket).





- Refer to the following when installing oil pan (2) (with oil pan gasket) and clips (1) to transmission case.

CAUTION:
- Never reuse oil pan gasket and oil pan mounting bolts.
- Install oil pan gasket in the direction to align hole position.
- Install it so that drain plug comes to the position as shown in the figure.
- Be careful not to pinch harnesses.
- Completely remove all moisture, oil and old gasket, etc. from oil pan mounting surface.





- Tighten oil pan mounting bolts to the specified torque in numerical order shown in the figure after temporarily tightening them. Tighten oil pan mounting bolts to the specified torque.