Scan Tool Testing and Procedures

DIAGNOSIS SYSTEM (AWD CONTROL UNIT)


CONSULT-III Function


FUNCTION
CONSULT-III can display each diagnostic item using the diagnostic test modes as follows.






ECU IDENTIFICATION
AWD control unit part number can be read.

SELF -DIAGNOSTIC RESULT
Before performing the self-diagnosis, start the engine and drive vehicle at 30 km/h (19 MPH) or more for approximately 1 minute.

Display Item List
Refer to Testing and Inspection.

How to Erase Self-Diagnostic Results
Before erasing DTC memory, start the engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute. Check that ABS warning lamp turns OFF.

NOTE:
When AWD warning lamp is ON with system malfunction of DTC "C1203", run the vehicle at 30 km/h (19MPH) or more for a minute and check that ABS warning lamp is turned OFF. Then turn ignition switch OFF, and start the engine again. Otherwise AWD warning lamp may not turned OFF even if it is normal.

DATA MONITOR

Display Item List

Display Item List:

ACTIVE TEST

Description
Use this mode to determine and identify the details of a malfunction based on self-diagnostic results or data monitor. AWD control unit gives drive signal to actuator with receiving command from CONSULT-III to check operation of actuator.

Test Item