Operation CHARM: Car repair manuals for everyone.

SBC


U1000 CAN COMM CIRCUIT





Description
- CAN (Controller Area Network) is a serial communication line for real time applications. It is an on board multiplex communication line with high data communication speed and excellent error detection ability. A modern vehicle is equipped with many ECMs, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, two control units are connected with two communication lines (CAN H-line, CAN L-line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only.
- It transmits the vehicle status to pre-crash seat belt control unit using the CAN communication system.
- It consists of CAN system (unified meter and A/C amp., ICC sensor, BCM, steering angle sensor).
- Refer to CAN System Specification Chart in LAN section for CAN communication unit (2WD).




DTC Logic

DTC DETECTION LOGIC

DTC Detection Logic:






DTC CONFIRMATION PROCEDURE
1.SELF-DIAGNOSIS WITH PRE-CRASH SEAT BELT CONTROL UNIT
1. Turn ignition switch ON and wait for 2 seconds or more.
2. Check "Self-diagnostic result" with CONSULT-III.
Is any DTC detected?
YES - Refer to CAN System Specification Chart in LAN section for CAN communication or
CAN system.
NO - CAN communication system is normal.