DCA

U1010 CONTROL UNIT (CAN)





ICC SENSOR INTEGRATED UNIT : Description
- CAN controller controls the communication of CAN communication signal and the error detection.
- CAN controller controls the communication of ITS communication signal and the error detection.




ICC SENSOR INTEGRATED UNIT : DTC Logic

DTC DETECTION LOGIC









ICC SENSOR INTEGRATED UNIT : Diagnosis Procedure
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn the DCA system ON.
2. Perform "All DTC Reading" with CONSULT-III.
3. Check if the "U1010" is detected as the current malfunction in self-diagnosis results of "ICC".
Is "U1010" detected as the current malfunction?
YES - Replace the ICC sensor integrated unit.
NO - INSPECTION END




ICC SENSOR INTEGRATED UNIT : Special Repair Requirement

DESCRIPTION
Perform the action test after adjusting the laser beam aiming of ICC sensor integrated unit when the following operation is performed.
- Removal and installation of ICC sensor integrated unit
- Replacement of ICC sensor integrated unit

SPECIAL REPAIR REQUIREMENT
1.LASER BEAM AIMING ADJUSTMENT OF ICC SENSOR INTEGRATED UNIT
Adjust the laser beam aiming of the ICC sensor integrated unit. Description.
- GO TO 2.
2.CHECK DCA SYSTEM
1. Erase the "self-diagnosis results", and then perform "All DTC Reading" again after performing the action test. ( DCA for action test.)
2. Check that the DCA system is normal.
- WORK END




ACCELERATOR PEDAL ACTUATOR : Description
CAN controller controls the communication of ITS communication signal and the error detection.




ACCELERATOR PEDAL ACTUATOR : DTC Logic

DTC DETECTION LOGIC









ACCELERATOR PEDAL ACTUATOR : Diagnosis Procedure
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn the DCA system ON.
2. Perform "All DTC Reading" with CONSULT-III.
3. Check if the DTC "U1010" is detected as the current malfunction in self-diagnosis results of "ACCELE
PEDAL ACT".
Is "U1010" detected as the current malfunction?
YES - Replace the accelerator pedal assembly.
NO - INSPECTION END




ACCELERATOR PEDAL ACTUATOR : Special Repair Requirement

DESCRIPTION
The accelerator pedal released position learning is necessary when the following operation is performed.
- Disconnection and connection of accelerator pedal assembly connector
- Replace accelerator pedal assembly

SPECIAL REPAIR REQUIREMENT
1.ACCELERATOR PEDAL RELEASED POSITION LEARNING
Perform the accelerator pedal released position learning. Description.
- GO TO 2.
2.CHECK DCA SYSTEM
1. Erase the "self-diagnosis results", and then perform "All DTC Reading" again after performing the action test. ( DCA for action test.)
2. Check that the DCA system is normal.
- WORK END