Assembly

HIGH AND LOW REVERSE CLUTCH


Assembly

1. Install drive plates, driven plates, retaining plate and snap ring to high and low reverse clutch drum.

CAUTION:





Check the order of plates.

1 : Snap ring
2 : Retaining plate
3 : Drive plate
4 : Driven plate
4/4 : Drive plate / Driven plate





2. Install snap ring to high and low reverse clutch drum with a flat-bladed screwdriver.





3. Install bearing race to high and low reverse clutch drum.

CAUTION:
Check the direction of needle bearing. Location of Adjusting Shims, Needle Bearings, Thrust Washers and Snap Rings.