Removal and Installation
TRANSMISSION ASSEMBLY
AWD : Removal and Installation
REMOVAL
CAUTION:
- When removing the A/T assembly from engine, first remove the crankshaft position sensor (POS) from the A/T assembly.
- Be careful not to damage sensor edge.
1. Disconnect the battery cable from the negative terminal.
2. Remove air cleaner case (RH). Exploded View.
3. Remove engine lower cover and front under cover with power tool. Exploded View.
4. Remove exhaust front tube and center muffler and with power tool. Exploded View.
5. Remove rear propeller shaft. Exploded View.
6. Remove front cross bar with power tool. Exploded View.
7. Remove exhaust mounting bracket. Exploded View.
8. Disconnect heated oxygen sensor 2 connectors (A).
White arrow: Vehicle front
Black arrow: Bolt
9. Remove heated oxygen sensor 2 harness (B) from clips (1).
10. Remove bracket (2) from transmission assembly.
11. Remove three way catalyst (right bank). Exploded View.
12. Remove front propeller shaft. Exploded View Removal and Installation, "Exploded
View".
13. Remove control rod. Exploded View.
14. Remove crankshaft position sensor (POS) from A/T assembly. Exploded View.
CAUTION:
- Never subject it to impact by dropping or hitting it.
- Never disassemble.
- Never allow metal filings, etc. to get on the sensor's front edge magnetic area.
- Never place in an area affected by magnetism.
15. Remove starter motor. Exploded View.
16. Remove rear plate cover. Exploded View.
17. Turn crankshaft, and remove the four tightening bolts for drive plate and torque converter.
CAUTION:
When turning the crankshaft, turn it clockwise as viewed from the front of the engine.
18. Support A/T assembly with a transmission jack.
CAUTION:
When setting the transmission jack, be careful not to allow it to collide against the drain plug.
19. Remove rear engine mounting member with power tool. Exploded View.
20. Remove engine mounting insulator (rear). Exploded View.
21. Remove dynamic damper. Exploded View.
22. Disconnect A/T assembly connector and harness clips.
23. Remove air breather hose. Exploded View.
24. Disconnect fluid cooler tube from the A/T assembly. Exploded View.
25. Remove bolts fixing A/T assembly to engine assembly with power tool.
26. Remove A/T assembly with transfer assembly from vehicle.
CAUTION:
- Secure torque converter to prevent it from dropping.
- Secure A/T assembly to a transmission jack.
27. Remove transfer assembly from A/T assembly with power tool. Exploded View.
INSTALLATION
Note the following, and Install in the reverse order of removal.
- When installing A/T assembly to the engine assembly, be sure to check dimension (A) to ensure it is within the reference value limit.
B : Scale
C : Straightedge
Dimension (A) : Refer to TM-276, "Torque Converter". Torque Converter
- When installing A/T assembly to the engine assembly, attach the fixing bolts in accordance with the following standard.
A : View from vehicle front
Circle: Transmission to engine
X : Engine to transmission
- Align the positions of tightening bolts for drive plate with those of the torque converter, and temporarily tighten the bolts. Then, tighten the bolts with the specified torque.
CAUTION:
- When turning crankshaft, turn it clockwise as viewed from the front of the engine.
- When tightening the tightening bolts for the torque converter after fixing the crankshaft pulley bolts, be sure to confirm the tightening torque of the crankshaft pulley mounting bolts. Exploded View.
- Rotate crankshaft several turns and check to be sure that A/T rotates freely without binding after converter is installed to drive plate.
- Install crankshaft position sensor (POS). Exploded View.