Removal and Installation

FRONT FENDER


Removal and Installation


CAUTION:
Use a shop cloth to protect the body from being damaged during removal and installation.

REMOVAL
1. Remove the following parts.
- LH side
Brake master cylinder cover and hood ledge cover (LH): Removal and Installation.
- RH side
Battery cover and hood ledge cover (RH): Removal and Installation.
2. Remove clips as shown in the figure by arrows, and remove hood seal assembly (side).










3. Remove fender protector. Removal and Installation.
4. Remove front bumper fascia. Removal and Installation.
5. Remove front combination lamp. Xenon Type (XENON TYPE) or Halogen Type (HALOGEN TYPE).
6. Remove front fender cover.
7. Remove fillet molding. Removal and Installation
8. Remove center mod guard. .
9. Remove mounting bolts except bolt of windshield side.
10. Loosen the mounting bolt (windshield glass side), then pull the front fender upward to remove it.

CAUTION:
- The mounting bolt (windshield glass side) can not be removed because there is not enough space, between the front fender and the windshield glass.
- A viscous urethane foam is installed on the back surface of front fender. When removing the front fender, peel of the urethane foam bit at a time, and carefully to remove it.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- After installation, check front fender adjustment. Adjustments and Adjustments.
- After installation, apply the touch-up paint (the body color) onto the head of front fender mounting bolts.
- Adjust the following part.
- Front combination lamp: Xenon Type (XENON TYPE) or Halogen Type (HALOGEN TYPE).
- Around view monitor (BOSE AUDIO WITH NAVIGATION): Without Navigation Without Navigation Calibrating Camera Image (Around View Monitor) Special Repair Requirement, "CALIBRATING CAMERA
IMAGE (AROUND VIEW MONITOR) : Special Repair Requirement"