No Force Generated For Putting Back The Accelerator Pedal

NO FORCE GENERATED FOR PUTTING BACK THE ACCELERATOR PEDAL


Description

The DCA switch can be turned ON/OFF but the actuation force of accelerator pedal is not generated.

NOTE:
- When the vehicle ahead detection indicator does not illuminate, the control and warning with the system are not performed.
- The actuation force of accelerator pedal may not be generated sufficiently depending on depressing method or depressing amount of accelerator pedal.




NO FORCE GENERATED FOR PUTTING BACK THE ACCELERATOR PEDAL


Diagnosis Procedure

1.PERFORM THE SELF-DIAGNOSIS
1. Perform "All DTC Reading" with CONSULT-III.
2. Check if any DTC is detected in self-diagnosis results of "ICC" or "ACCELE PEDAL ACT".
Is any DTC detected?
YES - GO TO 2.
NO - GO TO 3.
2.REPAIR OR REPLACE THE MALFUNCTIONING PARTS
Repair or replace malfunctioning parts. Testing and Inspection (ICC) or Testing and Inspection(ACCELE PEDAL ACT).
- GO TO 5.
3.PERFORM ACTIVE TEST
Check if the accelerator pedal actuator operates by the active test items "ACCELERATOR PEDAL ACTUATOR TEST1" and "ACCELERATOR PEDAL ACTUATOR TEST2" of "ACCELE PEDAL ACT" with CONSULT-III.
Does it operate?
YES - GO TO 4.
NO - Replace the accelerator pedal assembly.
4.CHECK VEHICLE AHEAD DETECTION PERFORMANCE
Understand the vehicle ahead detection condition when the malfunction occurred. If the detecting function is malfunctioning, check according to Description.
- INSPECTION END
5.CHECK DCA SYSTEM
1. Erase "self-diagnosis result", and then perform "All DTC Reading" again after performing the action test.
( DCA for action test.)
2. Check if the DCA system is normal.
- INSPECTION END