Camshaft Position Sensor (Phase)

INTAKE VALVE TIMING CONTROL


Camshaft Position Sensor (PHASE)


REMOVAL
1. Remove engine room cover using power tool. Service and Repair.
2. Remove air duct and resonator assembly. Removal and Installation.
3. Disconnect camshaft position sensor connector.





4. Remove camshaft position sensor (2) from Intake valve timing control solenoid valve cover (LH) (1).

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
Replace the O-ring (3) of the camshaft position sensor with a new one, then lubricate O-ring with engine oil before installing.

Camshaft position sensor bolt : 9.6 Nm (0.98 kg-m, 85 in-lb)