Control Module: Service and Repair

TRANSFER CONTROL UNIT


Removal and Installation


REMOVAL
1. Set transfer state as 2WD when 4WD shift switch is at 2WD, or as AUTO when 4WD shift switch is at
AUTO.

CAUTION:
When removing transfer control unit, transfer state must be at 2WD or AUTO.
2. Turn the ignition switch OFF and disconnect negative battery terminal.
3. Remove the lower instrument panel RH. Exploded View.





4. Disconnect the two transfer control unit connectors.
5. Remove the transfer control unit bolts.
6. Remove the transfer control unit.

INSTALLATION
Installation is in the reverse order of removal.
- When installing the transfer control unit, tighten bolts to the specified torque.

Transfer control unit bolts : 3.4 Nm (0.35 kg-m, 30 in-lb)


CAUTION:
Do not connect harness connector to transfer control unit when 4WD shift switch is at 4LO.
- After the installation, check perform self-diagnosis. Work Flow. If NG, adjust position between transfer assembly and transfer control unit. Precaution For Transfer Assembly and Transfer Control Unit Replacement.