Crash Zone Sensor

CRASH ZONE SENSOR


Removal and Installation


REMOVAL

CAUTION:
- Before servicing the SRS, turn the ignition switch off, disconnect both battery terminals and wait at least three minutes.
- Replace crash zone sensor if it has been dropped or sustained an impact.
- Do not disassemble crash zone sensor.
1. Disconnect both the negative and positive battery terminals, then wait at least three minutes.





2. Disconnect the crash zone sensor harness connector.
3. Remove crash zone sensor nuts.

INSTALLATION
Installation is in the reverse order of removal.
- After the work is complete, perform self-diagnosis to check that no malfunction is detected. Component Tests and General Diagnostics.