Tilt Sensor

TILT SENSOR


Diagnosis Procedure

Regarding Wiring Diagram information, Automatic Drive Positioner Control Unit.
1. CHECK TILT SENSOR SIGNAL





1. Turn ignition switch OFF.
2. Check voltage between automatic drive positioner connector and ground.





Is the inspection result normal?
YES - GO TO 4
NO - GO TO 2
2. CHECK HARNESS CONTINUITY





1. Disconnect automatic drive positioner control unit and tilt motor assembly.
2. Check continuity between automatic drive positioner connector
M33 (A), M34 (B) terminals 7, 33, 41 and tilt motor assembly connector M85 (C) terminals 2, 3, 4.

7 - 3 : Continuity should exist.
33 - 2 : Continuity should exist.
41 - 4 : Continuity should exist.

3. Check continuity between automatic drive positioner control unit connectors M33 (A), M34 (B) terminals 7, 33, 41 and ground.

7 - Ground : Continuity should not exist.
33 - Ground : Continuity should not exist.
41 - Ground : Continuity should not exist.

Is the inspection result normal?
YES - Replace tilt motor assembly. Tilt System.
NO - Repair or replace harness.
3. CHECK DOOR MIRROR OPERATION
1. Connect automatic drive positioner control unit and tilt motor assembly.
2. Turn ignition switch ON.
3. Check door mirror operation with memory function.
Is the operation normal?
YES - Replace tilt motor assembly. Tilt System.
NO - Replace automatic drive positioner control unit. Removal and Replacement.
4. CHECK INTERMITTENT INCIDENT
Intermittent Incident.
Is the inspection result normal?
YES - Replace automatic drive positioner control unit. Removal and Replacement.
NO - Repair or replace the malfunctioning part.