B2128

B2128 UART COMMUNICATION LINE





Description
Driver seat control unit performs UART communication with the automatic drive positioner control unit using 2 communication lines, TX and RX line. Driver seat control unit receives the operation signals of pedal adjusting switch, door mirror remote control switch, set switch and memory switch and the position signals of adjustable pedal sensor and door mirror sensor from the automatic drive positioner control unit and transmits the operation request signal.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE
1. STEP 1
Turn ignition switch ON.
- GO TO 2
2. STEP 2
Operate pedal adjusting switch for more than 2 seconds.
- GO TO 3
3. PROCEDURE 3
Check "Self diagnostic result" with CONSULT-III.
Is the DTC detected?
YES - Perform diagnosis procedure.
NO - Inspection End.




Diagnosis Procedure
Regarding Wiring Diagram information, Driver Seat Control Unit.
1. CHECK UART COMMUNICATION LINE CONTINUITY





1. Turn ignition switch OFF.
2. Disconnect driver seat control unit and automatic drive positioner control unit.
3. Check continuity between driver seat control unit harness connector and automatic drive positioner control unit harness connector.






4. Check continuity between driver seat control unit harness connector and ground.





Is the inspection result normal?
YES - Check intermittent incident. Intermittent Incident.
NO - Repair or replace harness.