C1111

C1111 ABS MOTOR, MOTOR RELAY SYSTEM





Description

PUMP
The pump returns the brake fluid stored in the reservoir to the master cylinder by reducing the pressure.

MOTOR
The motor drives the pump according to the signals transmitted by the ABS actuator and electric unit (control unit).




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSIS RESULTS
Check the self-diagnosis results.





Is above displayed on the self-diagnosis display?
YES - Proceed to diagnosis procedure. C1111.
NO - Inspection End




Diagnosis Procedure
Regarding Wiring Diagram information, Electrical Diagrams.
1.CONNECTOR INSPECTION
1. Turn ignition switch OFF.
2. Disconnect ABS actuator and electric unit (control unit) connector.
3. Check terminal for deformation, disconnect, looseness, and so on. If any malfunction is found, repair or replace terminal.
4. Reconnect connectors and then perform the self-diagnosis. Scan Tool Testing and Procedures.
Is any item indicated on the self-diagnosis display?
YES - GO TO 2
NO - Poor connection of connector terminal. Repair or replace connector.
2.CHECK ABS MOTOR AND MOTOR RELAY POWER SUPPLY CIRCUIT





1. Turn ignition switch OFF.
2. Disconnect ABS actuator and electric unit (control unit) connector.
3. Check voltage between the ABS actuator and electric unit (control unit) connector E125 terminal 1 and ground.





Is the inspection result normal?
YES - GO TO 3
NO - Repair or replace malfunctioning components.
3.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) GROUND CIRCUIT





Check continuity between ABS actuator and electric unit (control unit) connector E125 terminals 16, 47 and ground.





Is the inspection result normal?
YES - Replace ABS actuator and electric unit (control unit). Service and Repair.
NO - Repair or replace malfunctioning components.




Component Inspection
1.CHECK ACTIVE TEST
1. On "ACTIVE TEST", select "ABS MOTOR".
2. Touch "On" and "Off" on screen. Make sure motor relay and actuator relay operates as shown in table below.





Is the inspection result normal?
YES - Inspection End
NO - Go to diagnosis procedure. C1111.




Special Repair Requirement
1.ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
Always perform neutral position adjustment for the steering angle sensor when replacing the ABS actuator and electric unit (control unit). Description.
- GO TO 2
2.CALIBRATION OF DECEL G SENSOR
Always perform calibration of decel G sensor when replacing the ABS actuator and electric unit (control unit). Description.
- END