C1185

C1185 ICC UNIT





Description
When the force applied to brake pedal exceeds a certain level, the brake assist is activated and generates a greater braking force than that of a conventional brake booster, even with light pedal force.
When the ICC preview function identifies the need to apply the sudden brake by sensing the vehicle ahead in the same lane and the distance and relative speed from it, it applies the brake pre-pressure before driver depresses the brake pedal and improves brake response by reducing its free play.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSIS RESULTS
Check the self-diagnosis results.





Is above displayed on the self-diagnosis display?
YES - Proceed to diagnosis procedure. C1185.
NO - Inspection End




Diagnosis Procedure
Regarding Wiring Diagram information, Electrical Diagrams.
1.SELF-DIAGNOSIS RESULT CHECK
Perform self-diagnosis of ICC unit.
Are self-diagnosis result items displayed?
YES - After checking and repairing the applicable item, perform ICC unit self-diagnosis again.
NO - GO TO 2
2.CONNECTOR INSPECTION
Disconnect the ABS actuator and electric unit (control unit) connector and the ICC unit connector and check the terminals for deformation, disconnection, looseness or damage.
Is the inspection result normal?
YES - GO TO 3
NO - Repair or replace as necessary.
3.ICC UNIT CIRCUIT INSPECTION





1. Measure the continuity between ABS actuator and electric unit
(control unit) connector E125 terminal 7 and ICC unit connector
B13 terminal 10.





2. Measure the continuity between ABS actuator and electric unit
(control unit) connector E125 terminal 7 and body ground.





Is the inspection result normal?
YES - Replace ABS actuator and electric unit (control unit). Service and Repair.
NO - Repair or replace harness or connector.




Special Repair Requirement
1.ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
Always perform neutral position adjustment for the steering angle sensor when replacing the ABS actuator and electric unit (control unit). Description.
- GO TO 2
2.CALIBRATION OF DECEL G SENSOR
Always perform calibration of decel G sensor when replacing the ABS actuator and electric unit (control unit). Description.
- END