Initial Inspection and Diagnostic Overview

DIAGNOSIS AND REPAIR WORK FLOW


Work Flow


OVERALL SEQUENCE






DETAILED FLOW
1.INTERVIEW FOR MALFUNCTION
Interview the customer about the symptom.
- GO TO 2.
2.SYMPTOM CHECK
Verify the symptom from the customer's information.
- GO TO 3.
3.BASIC INSPECTION
Check the operation of each part. Check that no symptoms occur other than those specified by the customer.
- GO TO 4.
4.SELF-DIAGNOSIS WITH CONSULT-III
Perform the self diagnosis with CONSULT-III. Check that any DTC is detected.
Is any DTC detected?
YES - GO TO 5.
NO - GO TO 6.
5.TROUBLE DIAGNOSIS BY DTC
Perform the trouble diagnosis for the detected DTC. Specify the malfunctioning part.
- GO TO 7.
6.SYMPTOM DIAGNOSIS
Perform the symptom diagnosis. Specify the malfunctioning part.
- GO TO 7.
7.MALFUNCTIONING PART REPAIR
Repair or replace the malfunctioning part.
- GO TO 8.
8.REPAIR CHECK (SELF-DIAGNOSIS WITH CONSULT-III)
Perform the self diagnosis with CONSULT-III. Verified that no DTCs are detected. Erase all DTCs detected prior to the repair. Verify that DTC is not detected again.
Is any DTC detected?
YES - GO TO 5.
NO - GO TO 9.
9.REPAIR CHECK (OPERATION CHECK)
Check the operation of each part.
Does it operate normally?
YES - Inspection End.
NO - GO TO 3.