Special Repair Requirement (Preparation)

INSPECTION AND ADJUSTMENT


CAMERA AIMING ADJUSTMENT : Special Repair Requirement (Preparation)

1.PERFORM SELF-DIAGNOSIS
Perform self-diagnosis of lane camera unit.
Is any DTC detected?
Except "C1B01"-Perform diagnosis on the detected DTC and repair or replace the applicable item. Testing and Inspection.
"C1B01" or no DTC-GO TO 2.
2.PREPARATION BEFORE CAMERA AIMING ADJUSTMENT
1. Perform pre-inspection for diagnosis. LDW & LDP.
2. Adjust the tire pressure to the specified pressure value.
3. Maintain no-load in vehicle.
4. Check if coolant and Engine oil are filled up to correct level and fuel tank is full.
5. Shift the selector lever to "P" position and release the parking brake.
6. Clean the windshield.
7. Completely clear off the instrument panel.
- GO TO 3.
3. PREPARATION OF AIMING ADJUSTMENT JIG
Prepare the aiming adjustment jig according to the following procedure and the figure.
1. Print out the target mark attached in this service manual. Special Repair Requirement (Target Mark Sample).
2. Stick a printed target mark on the board with a scotch tape or a piece of double-sided tape.

NOTE:
- Use the board that peripheral area of the target is monochrome such as a white-board.
- Notice that the cross of the target is horizontal and vertical.











Diameter of a target (D) : 200 mm (7.87 in)
Height of a target center (H) : 1450 mm (57.09 in)
Width between a right target center : 600 mm (23.62 in)
from a left target center (W)


- Go to Special Repair Requirement (Target Setting).