Work Procedure With Automatic Back Door

CALIBRATION OF AUTOMATIC BACK DOOR POSITION INFORMATION


Work Procedure

1.STEP 1
1. Select "AUTOMATIC BACK DOOR CONTROL UNIT" using CONSULT-III.
2. Select "RESET AUTO BACK DOOR STATUS" of "WORK SUPPORT" mode.
3. Touch "NEXT" and "CLEAR" to erase automatic back door position information.
- GO TO 2.
2.STEP 2
Fully close the back door manually.
- GO TO 3.
3.STEP 3
Operate back door opener switch and perform automatic open operation.

NOTE:
At this time, automatic operation of back door is performed at half speed.
- GO TO 4.
4.STEP 4
1. The back door fully opens.
2. Check that hazard warning lamp blinks and automatic back door warning buzzer sounds normally.
Does hazard warning lamp blink and automatic back door warning buzzer sound normally?
YES - GO TO 5.
NO - GO TO 2.
5.STEP 5
Fully close the back door.
- WORK END