Removal And Installation

TRANSMISSION ASSEMBLY


AWD : Removal and Installation


REMOVAL

CAUTION:
- When removing the A/T assembly from engine, first remove the crankshaft position sensor (POS) from the A/T assembly.
- Be careful not to damage sensor edge.
1. Shift the selector lever to "P" position, and then release the parking brake.
2. Disconnect the battery cable from the negative terminal.
3. Remove control rod from A/T shift selector assembly. Exploded View.
4. Remove propeller shaft assembly (rear). Exploded View.
5. Remove propeller shaft assembly (front).
6. Remove manual lever from A/T assembly. Exploded View.
7. Support A/T assembly with a transmission jack.

CAUTION:
When setting the transmission jack, be careful not to allow it to collide against the drain plug and overflow plug.
8. Remove crankshaft position sensor (POS) from A/T assembly. Exploded View.

CAUTION:
- Never subject it to impact by dropping or hitting it.
- Never disassemble.
- Never allow metal filings, etc. to get on the sensor's front edge magnetic area.
- Never place in an area affected by magnetism.
9. Remove starter motor.
10. Remove rear plate cover. Exploded View.
11. Turn crankshaft, and remove the four tightening bolts for drive plate and torque converter.

CAUTION:
When turning the crankshaft, turn it clockwise as viewed from the front of the engine.
12. Remove A/T fluid cooler tubes. Exploded View.
13. Plug up openings such as the A/T fluid cooler tube hole.
14. Disconnect A/T assembly harness connector and AWD solenoid harness connector.
15. Remove harness and brackets.
16. Remove bolts fixing A/T assembly to engine with a power tool.
17. Remove air breather hose. Exploded View.





18. Remove A/T assembly with transfer assembly from vehicle.

CAUTION:
- Secure torque converter to prevent it from dropping.
- Secure A/T assembly to a transmission jack.
19. Remove transfer assembly from A/T assembly with a power tool.

INSTALLATION
Note the following, and Install in the reverse order of removal.

CAUTION:





Check fitting of dowel pin ( ).





- When installing A/T assembly to the engine, be sure to check dimension "A" to ensure it is within the reference value limit.

B : Scale
C : Straightedge

Dimension
"A" : Refer to "Torque Converter". Torque Converter





- When installing A/T assembly to the engine, attach the fixing bolts in accordance with the following standard.





- Align the positions of tightening bolts for drive plate with those of the torque converter, and temporarily tighten the bolts. Then, tighten the bolts with the specified torque.

CAUTION:
- When turning crankshaft, turn it clockwise as viewed from the front of the engine.
- When tightening the tightening bolts for the torque converter after fixing the crankshaft pulley bolts, be sure to confirm the tightening torque of the crankshaft pulley mounting bolts. Exploded View.
- Rotate crankshaft several turns and check to be sure that A/T rotates freely without binding after converter is installed to drive plate.