B2427

B2427 ENCODER





DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Operate automatic back door.
3. Check "Self Diagnostic Result" mode of "AUTOMATIC BACK DOOR CONTROL UNIT" using CONSULT-III.
Is DTC detected?
YES - RH With Automatic Back Door.
NO - INSPECTION END




Diagnosis Procedure
1.CALIBRATION OF AUTOMATIC BACK DOOR POSITION INFORMATION
1. Perform initialization setting of automatic back door position information. Work Procedure With Automatic Back Door.
2. Erase DTC, and then repeat "PERFORM DTC CONFIRMATION PROCEDURE".
Is DTC detected?
YES - GO TO 2.
NO - INSPECTION END
2.CHECK INSTALLATION OF BACK DOOR ASSEMBLY
1. Check that back door assembly is installed normally. With Automatic Back Door.
2. Check back door assembly mechanism deformation, looseness, rattle, interference with other parts, and pinched foreign materials.
Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace the malfunctioning parts.
3.CHECK ENCODER SIGNAL
1. Select "AUTOMATIC BACK DOOR CONTROL UNIT" using CONSULT-III.
2. Select "SPINDLE RH ENCODER A" and "SPINDLE RH ENCODER B" in "DATA MONITOR" mode.
3. Check that the function operates normally according to the following conditions.





Is the inspection result normal?
YES - GO TO 4.
NO - Replace automatic back door control unit. Automatic Back Door Control Unit.
4.CHECK ENCODER POWER SUPPLY
1. Turn ignition switch OFF.
2. Disconnect spindle unit RH connector.
3. Check voltage between spindle unit RH harness connector and ground.





Is the inspection result normal?
YES - GO TO 6.
NO - GO TO 5.
5.CHECK ENCODER CIRCUIT
1. Disconnect automatic back door control unit connector.
2. Check continuity between automatic back door control unit harness connector and spindle unit RH harness connector.





3. Check continuity between automatic back door control unit harness connector and ground.





Is the inspection result normal?
YES - Replace automatic back door control unit. Automatic Back Door Control Unit.
NO - Repair or replace harness.
6.CHECK ENCODER CIRCUIT 2
1. Disconnect automatic back door control unit connector.
2. Check continuity between automatic back door control unit harness connector and spindle unit RH harness connector.





3. Check continuity between automatic back door control unit harness connector and ground.





Is the inspection result normal?
YES - GO TO 7.
NO - Repair or replace harness.
7.CHECK ENCODER CIRCUIT 3
1. Connect automatic back door control unit spindle unit RH connector.
2. Check continuity between automatic back door control unit harness connector and ground.





Is the inspection result normal?
YES - GO TO 8.
NO - Replace automatic back door control unit. Automatic Back Door Control Unit.
8.CHECK INTERMITTENT INCIDENT
Intermittent Incident.
Is the inspection result normal?
YES - Replace automatic back door control unit. Automatic Back Door Control Unit.
NO - Repair or replace the malfunctioning parts.