Special Repair Requirement

INSPECTION AND ADJUSTMENT


CONFIGURATION (CAN GATEWAY) : Special Repair Requirement

1.WRITING MODE SELECTION
CONSULT-III Configuration
Select "CONFIGURATION" of CAN gateway.
When writing saved data-GO TO 2.
When writing manually-GO TO 3.
2.PERFORM "WRITE CONFIGURATION - CONFIG FILE"
CONSULT-III Configuration
Perform "WRITE CONFIGURATION - Config file".
- GO TO 4.
3.PERFORM "WRITE CONFIGURATION - MANUAL SELECTION"
CONSULT-III Configuration
1. Select "WRITE CONFIGURATION - Manual selection".
2. Select "SETTING".
3. When "COMMAND FINISHED", select "End".
- GO TO 4.
4.CHECK "SELF DIAGNOSTIC RESULT"
1. Perform "All DTC Reading" using CONSULT-III.
2. Check that all ECU self-diagnosis result have no U1000,U1001 and U1002.
- WORK END