Removal And Installation Navigation (Single Monitor)

AV CONTROL UNIT


Removal and Installation


CAUTION:
- Before replacing AV control unit, perform "READ CONFIGURATION" to save or print current vehicle specification. For details, Navigation (Single Monitor) Navigation (Single Monitor) Navigation (Single Monitor), "ADDITIONAL SERVICE WHEN REPLACING AV CONTROL
UNIT : Description".
- Remove battery terminal and AV control unit after a lapse of 30 seconds or more after turning the ignition switch OFF.

NOTE:
After the ignition switch is turned OFF, the AV control unit continues operating for approximately 30 seconds.
Therefore, data corruption may occur if battery voltage is cut off within 30 seconds.

REMOVAL
1. Remove front display unit. Exploded View Navigation (Single Monitor).
2. Remove AV control unit with a unified meter and A/C amp. as a single unit from the body.
3. Remove bracket screws, and then remove AV control unit.

INSTALLATION
Installation is the reverse order of removal.

CAUTION:
- Since AV control unit connector and unified meter and A/C amp. connector have the same form, be careful not to insert them wrongly.
- Be sure to perform "WRITE CONFIGURATION" when replacing AV control unit.