Assembly

FRONT CARRIER, INPUT CLUTCH, REAR INTERNAL GEAR


Assembly






1. Install input clutch component part (drive plates, driven plates and retaining plate) to input clutch drum. (TYPE 1)

1 : Snap ring
2 : Retaining plate
3 : Drive plate (six pieces)
4 : Driven plate (six pieces)

CAUTION:
Check order of plates.





2. Install input clutch component part (dish plate, drive plates, driven plates and retaining plate) to input clutch drum. (TYPE 2)

1 : Snap ring
2 : Retaining plate
3 : Drive plate (six pieces)
4 : Driven plate (six pieces)
5 : Dish plate

CAUTION:
Check order of plates.





3. Install snap ring to input clutch drum using a flat-bladed screwdriver.

CAUTION:
- Be careful not to scratch input clutch drum and input clutch retaining plate.
- Be careful not to damage snap ring.





4. Install needle bearing to input clutch assembly.

CAUTION:
Check the direction of needle bearing. 7AT RE7R01A Location of Needle Bearings and Bearing Races, "Location of Needle Bearings and Bearing Races".





5. Install O-ring (1) and seal rings (2) to input clutch assembly.





6. Install snap ring (1) to front carrier assembly.

CAUTION:
Be careful not to expand snap ring excessively.





7. Compress snap ring (1) using flat-bladed screwdrivers (A).

CAUTION:
- Be careful not to scratch rear internal gear.
- Be careful not to damage snap ring.
8. Install front carrier assembly and input clutch assembly to rear internal gear.





9. Install needle bearing (1) to front carrier assembly.

CAUTION:
Check the direction of needle bearing. 7AT RE7R01A Location of Needle Bearings and Bearing Races, "Location of Needle Bearings and Bearing Races".