Part 4

24. Apply final torque to the tilt motor pinch bolt.

^ Make sure the bolt is through the hole in the harness bracket.

^ Torque spec: 19 Nm (1.93 kg-m, 168 in-lb)





25. Attach tie-wrap to tilt motor and tilt motor harness as shown.

^ Tie wrap is included with tilt motor kit.





26. Install the Phillips head screw for the tilt sensor (see Figures 34 and 34a).

^ The tilt sensor is on the right side of the steering column.

^ Make sure the alignment indent is in the alignment hole.

^ Make sure the tilt sensor finger is in the bracket slot as shown in Figure 34a.





27. Prepare the telescope motor for installation:

a. Remove the bar-code sticker from the old motor and attach it to the new motor.





b. Apply a moderate amount of "TELESCO" grease to the threads on the telescope motor shaft as shown.

^ Do not use the entire tube of grease. Use only the amount needed.

^ The "TELESCO" grease is included in the Motor Assy - Tilt Kit (see Parts Information).

28. Connect the telescope motor electrical connector.





29. Hold the telescope motor in place as shown.

^ The screw should be centered to the retaining nut.





30. Run the telescope motor until the screw is threaded about 3/4 of the way in (down).

^ Use the telescope motor switch.





31. Install / mount the telescope motor bracket using the 2 small Allen head bolts.

^ Torque spec: 7 Nm (0.71 kg-m, 62 in-lb)





32. Use the telescope switch to run the motor out (up) toward the bracket until the bolt holes are aligned.








33. Install telescope motor pinch bolt and harness bracket (see Figures 40 and 41).

^ Make sure the harness bracket is in place.

^ Make sure the telescope sensor finger is in the harness bracket slot (see Figure 41).

^ Use the new nut supplied in the Motor Assy - Tilt Kit (see Parts Information).

^ Torque spec: 19 Nm (1.93 kg-m, 168 in-lb)





34. Attach tie-wrap around telescope motor and telescope motor harness as shown.

^ Tie-wrap is included with motor kit.

35. Operate the steering wheel tilt & telescope to their full positions (in - out - up - down). Make sure they operate correctly.

36. Install the steering column lower cover in reverse of removal.

37. Install the metal knee panel in reverse of removal.

EX





^ Make sure the climate control cabin temperature tube is located above the knee panel as shown.

FX





^ Make sure the climate control cabin temperature tube is located to the right of the knee panel as shown.

38. Install instrument lower panel LH as in reverse of removal.

39. Install instrument side finisher LH (EX only).

40. Set the ignition to the ACC position.

41. Install screws at front of steering column in reverse of removal.