Work Procedure

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT


ECM : Work Procedure

1.PERFORM ECM RECOMMUNICATING FUNCTION
1. Install ECM.
2. Contact backside of registered Intelligent key* to push-button ignition switch, then turn power supply position to ON.
*: To perform this step, use the key that is used before performing ECM replacement.
3. Maintain power supply position in the ON position for at least 5 seconds.
4. Turn power supply position to OFF.
5. Check that the engine starts.
- GO TO 2.
2.PERFORM ADDITIONAL SERVICE WHEN REPLACING ECM
Perform Work Procedure.
- END