RH

TOUCH SENSOR:_:RH





Component Function Check
1.CHECK FUNCTION
1. Select "AUTOMATIC BACK DOOR CONTROL UNIT" using CONSULT-III.
2. Select "TOUCH SEN RH" in "DATA MONITOR" mode.
3. Check that the function operates normally according to the following conditions.





Is the inspection result normal?
YES - Touch sensor RH is OK.
NO - SEE Diagnosis Procedure.




Diagnosis Procedure
1.CHECK TOUCH SENSOR RH INPUT SIGNAL
1. Turn ignition switch OFF.
2. Disconnect touch sensor RH connector.
3. Check voltage between touch sensor RH harness connector and ground.





Is the inspection result normal?
YES - GO TO 3.
NO - GO TO 2.
2.CHECK TOUCH SENSOR RH CIRCUIT
1. Disconnect automatic back door control module connector.
2. Check continuity between automatic back door control module harness connector and touch sensor RH harness connector.





3. Check continuity between automatic back door control module harness connector and ground.





Is the inspection result normal?
YES - Replace automatic back door control module. Automatic Back Door Control Module.
NO - Repair or replace harness.
3.CHECK TOUCH SENSOR RH GROUND CIRCUIT
Check continuity between automatic back door control module harness connector and touch sensor RH harness connector.





Is the inspection result normal?
YES - GO TO 4.
NO - Repair or replace harness.
4.CHECK TOUCH SENSOR RH
SEE Component Inspection.
Is the inspection result normal?
YES - GO TO 5.
NO - Replace touch sensor RH.
5.CHECK INTERMITTENT INCIDENT
Intermittent Incident.
- INSPECTION END




Component Inspection
1.CHECK TOUCH SENSOR RH
1. Turn ignition switch OFF.
2. Disconnect touch sensor RH connector.
3. Check continuity between touch sensor RH terminals.





Is the inspection result normal?
YES - INSPECTION END
NO - Replace touch sensor RH.