Work Procedure

TRANSMITTER WAKE UP OPERATION


Work Procedure

1.TRANSMITTER WAKE-UP PROCEDURE





1. Turn the ignition switch ON.
2. Press the transmitter activation tool (J-45295) (1) against the side of the tire at the location closest to the transmitter.
3. Wait until the indicator lamp turns OFF (approximately 5 seconds).

CAUTION:
Perform the wake-up procedure starting from the vehicle front left wheel, then repeat the procedure in the order of the front right wheel, rear right wheel, and rear left wheel.
4. Check that the low tire pressure warning lamp blinks in the pattern shown as per the following. The pattern indicates that the transmitter wake-up procedure for the wheel is completed.





5. Check that the hazard warning lamp blink twice when the transmitter wake-up procedure for all wheels is completed.
6. Check that the low tire pressure warning lamp turns OFF, after the transmitter wake-up procedure is completed for all wheels and turns OFF.
Is the transmitter wake-up completed?
YES - Perform the transmitter ID registration procedure. ID Registration.
NO - Perform trouble diagnosis for the transmitter. C1708.