Removal And Installation

TRANSFER HI-LO POSITION SENSOR


Removal and Installation


REMOVAL
1. Turn the ignition switch OFF.
2. Disconnect negative battery terminal.

CAUTION:
Wait for 5 seconds after turning ignition switch OFF.
3. Remove exhaust front tube (LH). Removal And Installation.
4. Support transfer assembly and transmission assembly with a jack.
5. Remove front suspension rear cross member with a power tool. Removal And Installation.
6. Remove rear engine mounting cross member with a power tool. Removal And Installation.
7. Remove heat insulator of exhaust front tube (LH).
8. Lower jack to the position where the transfer Hi-Lo position sensor can be removed.
9. Disconnect the transfer Hi-Lo position sensor connector.
10. Remove the transfer Hi-Lo position sensor.
11. Perform inspection after removal. Inspection.

INSTALLATION
Note the following, and install in the reverse order of removal.
- Never damage O-ring of transfer Hi-Lo position sensor.
- Perform inspection after installation. Inspection.