Work Procedure
TRANSFER LOCK POSITION SENSOR LEARNING
Work Procedure
NOTE:
In fail-safe mode, can not perform work support. (Except that DTC P181F or P182B is detected.)
1.PREPARATION BEFORE WORK
With CONSULT-III
1. Start the engine.
CAUTION:
Never drive the vehicle.
2. Check "4WD MODE", "T/M RANGE", "COMER VHCL SPEED", "MOTOR POWER SUP" of CONSULT-III
"DATA MONITOR" for "ALL MODE AWD/4WD".
3. Continue the following condition.
4WD MODE : 4L
T/M RANGE : N
COMER VHCL SPEED : 0 km/h (Never drive the vehicle)
MOTOR POWER SUP : More than 11 V
- GO TO 2.
2.PERFORM ERASE LOCK POSITION SENOR LEARNING
With CONSULT-III
1. Select "LOCK SLEEVE SENSOR INITIALIZE" of CONSULT-III "WORK SUPPORT" for "ALL MODE AWD/4WD".
2. Select "Start".
3. Wait until the motor operation stop.
- GO TO 3.
3.PERFORM LOCK POSITION SENOR LEARNING
With CONSULT-III
1. Select "LOCK SLEEVE SENSOR LEARNING" of CONSULT-III "WORK SUPPORT" for "ALL MODE
AWD/4WD".
2. Select "Start".
3. Wait until the motor operation stop.
- GO TO 4.
4.PERFORM SELF-DIAGNOSIS
With CONSULT-III
1. Erase self-diagnosis result for "ALL MODE AWD/4WD".
2. Turn the ignition switch ON to OFF.
CAUTION:
Wait for 10 seconds after turning ignition switch OFF.
3. Start the engine.
CAUTION:
Never drive the vehicle.
4. Perform self-diagnosis for "ALL MODE AWD/4WD".
Is "DTC P182B" detected?
YES - GO TO 1.
NO - WORK END