Work Procedure

TRANSFER ROTARY POSITION SENSOR LEARNING


Work Procedure


NOTE:
In fail-safe mode, can not perform work support. (Except that DTC P181F is detected.)
1.INITIAL CALIBRATION
With CONSULT-III
1. Start the engine.

CAUTION:
Never drive the vehicle.
2. Check "4WD MODE", "T/M RANGE", "COMER VHCL SPEED", "MOTOR POWER SUP" of CONSULT-III
"DATA MONITOR" for "ALL MODE AWD/4WD".
3. Continue the following condition.

4WD MODE : AUTO
T/M RANGE : N
COMER VHCL SPEED : 0 km/h (Never drive the vehicle)
MOTOR POWER SUP : More than 11 V

4. Select "START CALIBRATION" of CONSULT-III "WORK SUPPORT" for "ALL MODE AWD/4WD".
5. Wait till the motor operates. (Approx. 10 seconds)
- GO TO 2.
2.PERFORM SELF-DIAGNOSIS
With CONSULT-III
1. Erase self-diagnosis result for "ALL MODE AWD/4WD".
2. Turn the ignition switch ON to OFF.

CAUTION:
Wait for 10 seconds after turning ignition switch OFF.
3. Start the engine.

CAUTION:
Never drive the vehicle.
4. Perform self-diagnosis for "ALL MODE AWD/4WD".
Is "DTC P180D" detected?
YES - GO TO 1.
NO - WORK END