B260F

B260F ENGINE STATUS

Description

BCM receives the engine status signal from ECM via CAN communication.


DTC Logic


DTC DETECTION LOGIC

NOTE:
- If DTC B260F is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to
Security System.
- If DTC B260F is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to
Security System.






DTC CONFIRMATION PROCEDURE


1. PERFORM DTC CONFIRMATION PROCEDURE

1.Turn ignition switch ON under the following conditions.
-Selector lever is in the P or N position.
-Do not depress brake pedal.
2.Check "Self diagnostic result" with CONSULT.
Is DTC detected?
YES- Go to .
NO- INSPECTION END


Diagnosis Procedure


1. INSPECTION START

1.Turn ignition switch ON.
2.Check "Self diagnostic result" with CONSULT.
3.Touch "ERASE".
4.Perform DTC Confirmation Procedure.
See .
Is the DTC B260F displayed again?
YES- GO TO 2.
NO- GO TO 3.

2. REPLACE ECM

Replace ECM. Description.
- INSPECTION END

3. CHECK INTERMITTENT INCIDENT

Intermittent Incident.
- INSPECTION END