LDW & LDP

DIAGNOSIS AND REPAIR WORK FLOW

Work Flow


OVERALL SEQUENCE







DETAILED FLOW


1. INTERVIEW FOR MALFUNCTION

Interview the customer to obtain information about symptoms using "Diagnostic Work Sheet". (Diagnostic Work Sheet.)
- GO TO 2.

2. SELF-DIAGNOSIS WITH CONSULT

Perform self-diagnosis with CONSULT. Check if any DTC is detected.
Is any DTC detected?
YES- GO TO 5.
NO- GO TO 3.

3. PRE-INSPECTION FOR DIAGNOSIS

Perform pre-inspection for diagnosis. LDW & LDP.
- GO TO 4.

4. VERIFY CUSTOMER CONCERN (ACTION TEST)

Perform action test and verify the customer's information. LDW & LDP.
- GO TO 6.

5. TROUBLE DIAGNOSIS BY DTC

Perform trouble diagnosis for the detected DTC. Specify a malfunctioning part. A L L Diagnostic Trouble Codes ( DTC )
(Lane camera unit) and/or A L L Diagnostic Trouble Codes ( DTC ) [ABS actuator and electric unit (control unit)].
- GO TO 7.

6. SYMPTOM DIAGNOSIS

Perform symptom diagnosis. Specify malfunctioning part. LDW & LDP System Symptoms.
- GO TO 7.

7. MALFUNCTION PART REPAIR

Repair or replace the identified malfunctioning parts.
- GO TO 8.

8. REPAIR CHECK (SELF-DIAGNOSIS WITH CONSULT)

Perform self-diagnosis with CONSULT. Check that any DTC is not detected. Erase DTC if DTC is detected before the repair. Check that DTC is not detected again.
Is any DTC detected?
YES- GO TO 5.
NO- GO TO 9.

9. REPAIR CHECK (ACTION TEST)

Perform action test. Also check the system operation.
Does it operate normally?
YES- INSPECTION END
NO- GO TO 4.