Removal And Installation

FRONT DOOR LOCK

DOOR LOCK : Removal and Installation


REMOVAL

1.Remove front door finisher. Removal And Installation (driver side) or
Removal And Installation (passenger side).
2.Remove front door glass. Removal And Installation.
3.Remove front door module assembly. Removal And Installation.
4.Disconnect door antenna and door request switch connector and remove harness clamp (with Intelligent
Key system model) on outside handle bracket.





5.Remove door side grommet, and loosen TORX bolt from grommet hole.

CAUTION:
Never remove TORX bolt forcibly.










6.Reach in to separate key rod (2) connection [on the door key cylinder assembly (1)] (driver side).





7.While pulling outside handle, remove door key cylinder assembly (driver side) or outside handle escutcheon (passenger side).





8.While pulling outside handle (1), slide toward rear of vehicle to remove outside handle.
9.Remove front gasket and rear gasket.





10.While pulling outside handle bracket, slide toward rear of vehicle to remove outside handle bracket.
11.Reach in to separate outside handle cable connection on outside handle bracket.
12.Remove door lock assembly TORX bolts.
13.Disconnect door lock actuator connector, and then remove door lock assembly.
14.Remove key rod from door lock assembly.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
- When installing each rod, rotate rod holder until a click is felt.
- Check door open/close, lock/unlock operation after installation.