Front Pad Inspection

FRONT DISC BRAKE

BRAKE PAD : Inspection


INSPECTION AFTER REMOVAL

Replace the shims and the shim covers if rust is excessively attached.

INSPECTION AFTER INSTALLATION

1.Check a drag of front disc brake. If any drag is found, follow the procedure described below.
2.Remove brake pads.
3.Press the pistons.

CAUTION:
- Never damage the piston boot.
- When replacing a pad with new one, check a brake fluid level in the reservoir tank because brake fluid returns to master cylinder reservoir tank when pressing piston in.
NOTE:
Use a disc brake piston tool to easily press piston.
4.Install brake pads.
5.Depress the brake pedal several times.
6.Check a drag of front disc brake again. If any drag is found, disassemble the cylinder body. Front Disc Brake
7.Burnish contact surfaces after refinishing or replacing brake pads, or if a soft pedal occurs at very low mileage. Inspection.