Diagnosis Procedure

MIRROR SENSOR

DRIVER SIDE : Diagnosis Procedure


1. CHECK DOOR MIRROR (DRIVER SIDE) SENSOR POWER SUPPLY

1.Turn ignition switch OFF.
2.Disconnect door mirror (driver side) connector.
3.Turn ignition switch ON.
4.Check voltage between door mirror (driver side) harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 2.

2. CHECK DOOR MIRROR (DRIVER SIDE) SENSOR POWER SUPPLY CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect automatic drive positioner control unit connector.
3.Check continuity between automatic drive positioner control unit harness connector and door mirror (driver side) harness connector.





4.Check continuity between automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES- Replace automatic drive positioner control unit. Removal And Installation.
NO- Repair or replace harness or connector.

3. CHECK DOOR MIRROR (DRIVER SIDE) SENSOR GROUND

1.Turn ignition switch OFF.
2.Disconnect driver seat control unit connector.
3.Check continuity between automatic drive positioner control unit harness connector and door mirror (driver side) harness connector.





Is the inspection result normal?
YES- GO TO 4.
NO- Repair or replace harness or connector.

4. CHECK DOOR MIRROR (DRIVER SIDE) SENSOR CIRCUIT

1.Check continuity between automatic drive positioner control unit harness connector and door mirror (driver side) harness connector.





2.Check continuity between automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES- Replace door mirror sensor. (Built in driver side mirror.)
NO- Repair or replace harness or connector.