Removal and Installation

BACK DOOR

BACK DOOR ASSEMBLY : Removal and Installation


CAUTION:
- Operate with two workers, because of its heavy weight.
- Use protective tape or shop cloth to protect from damage during removal and installation.
NOTE:
The back door harness constitute the back door assembly.

REMOVAL

1.Remove back door finisher inner and back door plate. Removal And Installation.
2.Remove clips of headlining at rear end. Removal And Installation.
3.Disconnect connectors and remove bolts of back door harness.
4.Remove back door grommet (LH), and then pull harness out of vehicle at roof panel hole.
5.Remove back door plate, and then disconnect washer tube. Exploded View and Rear Washer Nozzle And Tube.
6.Pull washer tube out of back door.
7.Support back door lock with the proper material to prevent it from falling.

WARNING:
Bodily injury may occur if no supporting rod is holding the back door open when removing the back door stay.
8.Remove spindle unit. Removal And Installation.
9.Remove back door hinge mounting bolts on back door and remove back door assembly.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:
- After installation, perform the fitting adjustment. Adjustments.
- Perform initialization setting of automatic back door system. Work Procedure.
- After installation, check back door open/close, lock/unlock operation.
- Check back door hinge rotating part for poor lubrication. If necessary, apply body grease.
- After installation, perform the camera image calibration. Work Procedure.