Key Slot Illumination

KEY SLOT ILLUMINATION

Description

Blinks when Intelligent Key insertion is required.


Component Function Check


1. CHECK FUNCTION

Check key slot illumination ("KEY SLOT ILLUMI") Active Test mode.
Is the inspection result normal?
YES- Key slot function is OK.
NO- .


Diagnosis Procedure


1. CHECK FUSE

1.Turn ignition switch OFF.
2.Check 10 A fuse, [No.9, located in fuse block (J/B)].
Is fuse fusing?
YES- Replace the blown fuse after repairing the affected circuit if a fuse is blown.
NO- GO TO 2.

2. CHECK KEY SLOT ILLUMINATION OUTPUT SIGNAL

Check voltage between key slot harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 4.

3. CHECK KEY SLOT CIRCUIT

1.Disconnect BCM and key slot connector.
2.Check continuity between BCM harness connector and key slot harness connector.





3.Check continuity between BCM harness connector and ground.





Is the inspection result normal?
YES- Replace BCM. Removal And Installation.
NO- Repair or replace harness.

4. CHECK KEY SLOT POWER SUPPLY CIRCUIT

1.Disconnect key slot connector.
2.Check voltage between key slot harness connector and ground.





Is the inspection result normal?
YES- GO TO 5.
NO- Repair or replace harness.

5. CHECK KEY SLOT GROUND CIRCUIT

Check continuity between key slot harness connector and ground.





Is the inspection result normal?
YES- GO TO 6.
NO- Repair or replace harness.

6. CHECK KEY SLOT

.
Is the inspection result normal?
YES- GO TO 7.
NO- Replace key slot. Removal And Installation.

7. CHECK INTERMITTENT INCIDENT

Intermittent Incident.
- INSPECTION END


Component Inspection


1. CHECK KEY SLOT ILLUMINATION

1.Turn ignition switch OFF.
2.Disconnect key slot connector.
3.Connect battery power supply to key slot terminals 5 and 6, and check the operation.





Is the inspection result normal?
YES- INSPECTION END
NO- Replace key slot. Removal And Installation.