System Description
DOOR MIRROR SYSTEM
System Description
MANUAL FUNCTION
Description
- Automatic drive positioner control unit controls door mirror.
- Automatic drive positioner control unit inputs changeover switch signal and performs the LH/RH control of door mirror motor supplying electric power when changeover switch is operated.
- Automatic drive positioner control unit inputs mirror switch signal and supplies electric power to door mirror.
- The ignition switch signal (ACC/ON) is transmitted from BCM to the driver seat control unit via CAN communication and from the driver seat control unit to the automatic drive positioner control unit via UART communication.
- Power is supplied to folding motor when operating the open/close switch.
Operation Conditions
If the following conditions are not satisfied, operation is not performed.
- Ignition switch: ON or ACC
- Changeover switch: Select either left or right
REVERSE INTERLOCK DOOR MIRROR SYSTEM
Description
- Select one of the door mirror faces using change over switch, and then set the selected mirror face downward/inward.
- When the ignition switch is in the ON position and A/T shift selector is in the R position, the TCM sends the
R signal to the driver seat control unit. The R signal is transmitted to the automatic drive positioner control unit from the driver seat control unit via UART communication. When the R signal is detected, the automatic device positioner control unit activates the mirror motor.
Operation Conditions
If the following conditions are not satisfied, operation is not performed.
- Ignition switch: ON
- Changeover switch: Select either left or right
- A/T shift selector: R position
During the reverse interlock door mirror system, if all of the above conditions are not satisfied, mirror face returns to original angle.
Mirror Angle Memory Function
- During the reverse interlock door mirror operation, the mirror angle can be changed. After adjustment, the mirror face positions can be memorized (2 positions). For memory setting.
- Initial setting is downward 7�, inward 1� (both of left and right).
- When the drivers seat, door mirror and steering column are not in the memorized position, the door mirror moves to the initial tilt-down angle, if the reverse tilt-down position is stored. Linking Intelligent Key to a stored memory position.
Memory Procedure
1.Apply the parking brake.
2.Push the ignition switch to the ON position. (Do not start the engine)
3.Push the memory switch 1 or 2 fully for at least 1 second to operate the automatic drive positioner.
4.Turn the door mirror control switch (changeover switch) to L (left).
5.Depress the brake pedal.
6.Move the A/T shift selector to the R position (reverse).
7.Adjust the mirror to the desired viewing position for backing up by operating the door mirror control switch (mirror switch).
8.Push the SET switch and, within 5 seconds, push fully the memory switch 1 or 2 selected in step 3 for at least 1 second.
The indicator light for the pushed memory switch illuminates, and continue pushing the switch. After the indicator light tams off, the selected mirror position is stored in the selected memory (1 or 2).
9.Turn the door mirror control switch (changeover switch) to R (right).
Repeat the above procedure to adjust the right mirror position and store in the selected memory.
AUTOMATIC DRIVE POSITIONER SYSTEM LINKED OPERATION
Description
Door mirror control is included in automatic drive positioner system. Refer to automatic drive positioner system for more details.
System Description.