Rear Seat

REAR SEAT

Disassembly and Assembly


SEATBACK

Disassembly
1.Remove the seatback board.





Remove the clips.





2.Remove the armrest assembly. (RH seat only)





a.Remove the hog lings, and then pull the seatback trim.
b.Remove the metal clips and pawl, and then pull out armrest bracket cover.










c.Remove the mounting bolts (A), and then remove the armrest bracket (1).
d.Remove the armrest assembly.
3.Remove the reclining device cover.





Remove the screws (A) and clip (B), and then reclining device inner cover (1) and reclining device inner cover inside (2).
4.Remove the reclining lever knob assembly.





a.Remove the push nut (1), cable resin part (2) and cable clamp (3).





b.Remove the hog rings (A) and cable clamp.
c.Remove the reclining lever knob cap.





d.Remove the screw (B), and then remove reclining knob lever assembly (4).
5.Remove the seatback trim and pad.
a.Remove the seatback hinge outer cover.





b.Remove the mounting bolt (A) and then remove seatback hinge.
c.Remove the hog rings from back side.
d.Remove the seatback retainer.
e.Remove the seat belt finisher. Removal And Installation.





f.Remove the headrest holder.

CAUTION:
Before installing headrest holder check its orientation.
(front/rear and right/left)
g.Remove the seatback trim and pad.
h.Remove the hog rings to separate the seatback trim and seatback pad.
6.Remove the reclining device (LH). (LH seat only)





Remove the mounting bolts (A), and then remove reclining device (LH).
7.Remove the dynamic damper.





Remove the dynamic damper mounting nuts (A).
8.Remove the seat belt hook.
9.Remove the rear center seat belt retractor. Removal And Installation.
Assembly
Assemble in the reverse order of disassembly.

CAUTION:





- Always slacken cable end and link pin when installing reclining lever knob cable.





- Always install in the position that the reclining device lock can be released, because cable resin part is adjustable (3


stages).
- Install the hog rings of seatback trim in position, and then securely connect the trim or trim cord with the seatback frame.

SEAT CUSHION

Disassembly
Remove the hog rings to separate the trim and pad.
Assembly
Assemble in the reverse order of disassembly.

CAUTION:
Install the hog rings of seat cushion trim in position, and then securely connect the trim or trim cord with the seat cushion pad wire.

ARMREST

Disassembly
1.Remove the cup holder.





Remove the metal clips and pawls.





2.Remove the armrest lid assembly.
Remove the fixing screw.
3.Remove the armrest strap.





a.Open the fastener (1), and then pull up armrest trim.





b.Remove the mounting bolt (A), and then remove armrest strap (2).
Assembly
Assemble in the reverse order of disassembly.