Removal And Installation

FRONT DOOR LOCK

DOOR LOCK : Removal and Installation


REMOVAL

1.Remove front door finisher. Removal And Installation.
2.Remove front door glass. Removal And Installation.
3.Remove front door module assembly. Removal And Installation.
4.Remove door key cylinder assembly (outside handle escutcheon), outside handle, outside handle bracket, rear gasket and front gasket. Removal and Installation.
5.Remove door lock assembly TORX bolts.
6.Disconnect door lock actuator connector, and then remove door lock assembly.
7.Remove key rod from door lock assembly.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
- Check door lock cables are properly engaged with inside handle and outside handle.
- When installing key rod, rotate key rod holder until a click is felt.
- After installation, check door open/close, lock/unlock operation.