Removal And Installation

BACK DOOR LOCK

TOUCH SENSOR : Removal and Installation


CAUTION:
Never bend touch sensor.

REMOVAL

1.Remove back door finisher inner. Removal And Installation.





2.Disconnect touch sensor harness connector (A).
3.Remove fixing clips, and then remove touch sensor.

CAUTION:
When removing touch sensor, peel off the double-sided tape one strip at a time, and carefully remove it.





4.Remove grommet (1).
5.Pull harness (2) of touch sensor out of back door (3) and remove touch sensor (4).

INSTALLATION

Note the following item, and then install in the reverse order of removal.

CAUTION:
- Before installation, remove double sided-tape that remains no touch sensor and back door.





- Apply primer for plastic to touch sensor and back door, on the area to be covered by double-sided tape, and then install touch sensor using double sided-tape (1).


Double-sided tape: 0.6 mm (0.024 in)
- Install touch sensor and back door without clearance.
- Check back door open/close operation after installation.