Without ADP

DOOR MIRROR

GLASS MIRROR : Removal and Installation


DISASSEMBLY

1.Place the glass mirror upward.





2.Put a strip of protective tape (B) on housing assembly.
3.As shown in the figure, insert a remover tool (A) between glass mirror (1) and actuator (2). Push up both pawls simultaneously to remove glass mirror lower half side.
NOTE:
Insert a remover tool into recesses, and push up while rotating (twisting) to make work easier.
4.Remove two terminals of mirror heater attachment.
5.Lightly lift up lower side of glass mirror, and detach both pawls of upper side as if pulling it out to disassemble glass mirror from actuator.
NOTE:
Be careful not to allow grease on sealing agent in center of mirror or back side of glass mirror.

ASSEMBLY

Assemble in the reverse order of disassembly.

CAUTION:
After installation, visually check that pawls are securely engaged.