Removal And Installation

COMPRESSOR

Removal and Installation


REMOVAL

1.Remove cooling fan assembly. Exploded View.
2.Remove low-pressure pipe 3. Exploded View.
3.Remove drive belt. Removal And Installation.





4.Remove mounting nut (A), and then disconnect high-pressure flexible hose (1).

CAUTION:
Cap or wrap the joint of the A/C piping and compressor with suitable material such as vinyl tape to avoid the entry of air.





5.Disconnect compressor (ECV) connector (A).
6.Disconnect compressor (magnet clutch) connector (B).
7.Remove harness fixing clip (C)





8.Remove mounting bolt (A), and water suction pipe (1) a position without the hindrance for work. Exploded View.
9.Remove floor under cover. Exploded View.





10.Remove mounting bolt (A), and then remove harness bracket a position without the hindrance for work.
11.Remove mounting bolt (B) from compressor (1).





12.Remove mounting bolts (A), and then remove compressor from upper side of the vehicle.

INSTALLATION

Note the following items, and then install the reverse order of removal.

CAUTION:
- Replace O-rings with new ones. Then apply compressor oil to them when installing.
- Check for leakages when recharging refrigerant.
- Check tension of the drive belt after installing compressor. Procedures.