Description

HEADLAMP AIMING ADJUSTMENT

Description


PREPARATION BEFORE ADJUSTING

NOTE:
- For details, refer to the regulations in your own country.
- Perform aiming if the vehicle front body has been repaired and/or the headlamp assembly has been replaced.
- Adjust the tire pressure to the specification.
- Fill with fuel, engine coolant and each oil.
- Maintain the unloaded vehicle condition. (Remove luggage from the passenger compartment and the luggage room.)
NOTE:
Do not remove the temporary tire, jack and on-vehicle tool.
- Wipe out dirt on the headlamp.

CAUTION:
Never use organic solvent (thinner, gasoline etc.)
- Ride alone on the driver seat.
- Headlamp aiming switch sets to "0". (with manual headlamp aiming control system.)

AIMING ADJUSTMENT SCREW











NOTE:
The figure is the vehicle without AFS. Each adjustment screw is applied to the vehicle with AFS.