Removal And Installation

REAR ACTIVE STEER

Removal and Installation


REMOVAL

1.Remove coil spring and rear lower link. Exploded View.
2.Disconnect harness connector from RAS actuator assembly and rear suspension member.
3.Remove fixing bolts and nuts of RAS actuator assembly, and then remove RAS actuator assembly from rear suspension member.

INSTALLATION

Note the following, and install in the reverse order of removal.
- When installing RAS actuator assembly to rear suspension member, check the mounting surfaces of RAS
actuator assembly and rear suspension member for oil, dirt, sand, or other foreign materials.
- Check rear wheel alignment. Rear Suspension Alignment Inspection.
- Adjust neutral position of steering angle sensor. Special Repair Requirement.